Approx weight 10,000 lbs
Working width 60"
Sanding belt size 64" x 103"
Main motor 40 HP
Contact drum 11.5 " dia. Approx 45 durometer
Electrics 460 volt three phase 60 Hz, full load amps 52, recommended 60-amp
Compressed air supply needed 90 PSI @ 2 CFM
Automatic reversing table
Electronic belt tracking (super nice)
Stainless steel enclosure
Variable speed 20 to 40 FPM (we will run mostly at 20 FPM)
Motorized thickness adjustment, hand wheel fine adjustment)
Complete pump and filtration system
Name plate on machines largest motor says
Name plate on another smaller motor says
Conveyor belt measures 64" wide
Coolant uses a trimsol
Measured decibels while cutting Quiet 75 dcb
Replacement cost of this machine would be about $120,000
Takes five minutes to change belt with two people.
AUTO reverse set up is built for only running about three feet. Jumper
leads installed for longer pieces. (about 20')
BOUGHT FROM REFURBISHER 2004 AND NOT USED AGAIN
to our home page