This is a 2007 Flow IFB 6' x 12' abrasivejet cutting system. The machine has
approx. 5000 hrs. of run time on it and is currently in very good condition.
System has many up grade options with it. The following is a list of options.
Dynamic cutting wrist to compensate for taper
Flow waterveyer abrasive removal system
Air conditioned control cabinet to protect electronics
Vac-assist for piercing for brittle materials and laminates
Height sensor to automatically adjust nozzle stand off
System is currently under power, cutting good parts and is available for on
site visit. System has a 72" x 144" cutting envelope.
This is the 50Hp 60 Kpsi pump. These pumps are integrated into system and pump
is controlled by the Flow master software that runs the system. There are a
number of electronic sensors that warn if there is a problem and can identify
what area to look at for service. There is
mounted larger casters onto base to make
it easier to pull pump out for servicing. Easy access makes this pump easy to
work on and minimize down time.
This is one of the best options of any waterjet system. The Dynamic cutting
head eliminates taper from parts allowing for much tighter tolerances than
standard 2D waterjet systems can offer. This machine comes with the new Vented
cutting head that dramatically reduces orifice failure. Cutting head is shown
here along with the Vac-assist option. There is also a height sensor that
mounts next to head (not shown here). Height sensor touchs down on material to
automatically adjust cutting head height.
EXCELLENT CONDITION UNDER POWER
to complete inventory display
to our home page