ROUNDO R - 13S Angle Bending Roll
Machine Specifications and List of Tooling and Attachments
Larger than Standard Diameter Shafts on Rolls (mm vs. mm)
Machine is equipped with the Shafts, Motors, and Drives that are normally
found on the R-15S Model machine, but in the R-13S Frame
Machine Weight is approximately 120,000 Lbs. versus 88,000 Lbs. Standard
The approximate Foot Print of the Machine is 155" x 218", not including the
Digital Position Indicators for the (2) rear adjustable rolls
Roll Bolt & CAP Assemblies are made of (3) different height sections, which
are split halves and can be removed easily for quick adjustment of the
Beam-on-Edge Device (Hydraulically Powered), with (3) Sets of Pulling
Hydraulic Pressure Guage in clear view during operation of device.
Adjustable Guide Rolls that are Hydraulically Controlled in (3) directions:
Up/down: In/out(front to back); and rotating (left/right)
Various Dies and Spacers including the following:
Standard se of Angle / Bar Rolling Dies
(grooved for capture of Beam Flanges when rolling the Easy Way)
Set of Square / Rectangular Tubing Dies
Dies are reversible and made for both 3/8" and 1/2" wall tubing
Various Spacer Sets used for the Rolling of Beams on Edge, Rolling Beams and
Channels the Easy Way, Spacing the Dies for Bars, Tubing, etc.
(7) sets of pipe rolling dies including: 8" 10" 12" 14" 16" 18" and 20"
diameters. These die sets are mounted stands that are easily removable via
Numerous bolts and Fasteners for the attachment of die and Spacer sets
(3) Powered in-feed Rollers with Rolls made from 12" diameter x 3/4" Wall tube
(4) Portable support roll-stands for supporting materials during the rolling
process. Stands are hydraulically adjustable for various heights.
to complete inventory display
to our home page